SONNENWIESE
PAGE 11
5000511/11.19
Maintenance
5.3.
Moving the device into the maintenance/tanning
position
Caution!
Before starting maintenance or repair work, disconnect the device from the power supply.
Moving the device into the maintenance position
1.
Remove the four wire cables (
4/2
) from the clamp
hooks (
4/1
).
2.
Unwind the four wire cables and let them hang down.
3.
Using the unblocking tool (
4/5
), press and hold the small
flange (
4/3
) of the wire-cable holder (
4/4
).
.
The wire-cable holder can be lowered.
4.
Place the device in the required position along the wire
cables.
5.
Once the maintenance work has been completed, slide the
device back into the tanning position.
1
2
3
4
5
4
Moving the device into the tanning position
1.
Using the unblocking tool (
4/5
), push the wire-cable
holder (
4/4
) and thereby the device along the wire cables
towards the ceiling.
.
The wire-cable holders will hold themselves in any position.
2.
Push the device toward the ceiling until:
d
The housing rests flush against the ceiling if it is a concrete
ceiling
d
The bracket around the circumference of the housing rests
flush against the suspended ceiling if it is a suspended
ceiling.
3.
Wind the attachment cables (
4/2
) together in a loop and
fasten them to the lower surface of the housing using the
intended clamp hooks (
4/1
).