COMPONENT ACCESS
Built-In Single and Double Wall Ovens
n
4-7
REMOVING THE PROBE JACK ASSEMBLY
From the right side of the oven remove the side
insulation cover (top front and rear service
covers are also removed).
Pull the insulation back to expose the jack
assembly and pull (fish) the jack wiring harness
out.
REMOVING THE OVEN DOOR
It may be easier servicing the next few
components with the oven door and oven
racks removed.
Open the oven door.
At the two door hinge locations will be a hinge
lock retainer. Lift the hinge retainers all the way
to the stop position.
Grasp the door at each side and close the door
until it stops.
Once it is stopped, push the upper portion of the
door toward the oven cavity and the hinges will
release.
Set the door aside.
From inside the oven (right side wall) remove a nut
that mounts the jack in place.
From outside the oven remove the back service
panel and disconnect the probe electrical
connection.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
