KisanKraft
™
SELF PROPELLED REAPER
KK-SPR-1201P / 1202DV / 1203DH
: www.kisankraft.com
: +91.80.22178200
Page 22 of 72
OPERATION
Warning
:
Please refer to the following regulations to avoid any accident.
Install the shell removed after checking and Working
. Don’t put any flammable
things near the vent of the muffler.
Open the windows and doors for ventilation to avoid any gas poisoning if the
machine starts up indoors.
Do confirm the positions of the moving clutching handle (unoccupied), the
master clutch handle (separated) and the harvester’s clutch handle (separated)
and notice whether there are children or others before starting up.
A. Preparation and Startup:
1. Check the lubrication of the cases and the connecting bolts.
2.
Place the clutch handle on the position of “separating”, the tap handle on the
neutral gear, and the accelerator on “startup”.
3. Start up the engine.
B. Stepping :
1.
Place the tap handle on “gear” position.
2. Place the belt
clutch handle on “gear” position smoothly, so as to make the
machine step stably.
3.
Place the gear case’s clutch handle on “gear” position for the trial running of the
cutter.
C. Gear Shifting & Reversing:
1.
Place the belt clutch handle on “separating” position.
2. Place the tap handle on gear reversing position.
3.
Place the belt clutch handle on “gear” position smoothly, so as to make the
machine walk backward (or forward).
4. Please have the gear shifting after stopping the machine. It is strictly forbidden
to shift the gear while moving.
5. If failed to put into gear once, connect the clutch handle and separate, and then
put into gear again. Do not put into gear by force, which can damage the gears.
D. Turning:
For turning right, hold the right turning handle tightly. For turning left, hold the left
turning handle tightly.
E. Operation on Field:
1. The height of the cutting stubble is determined by the operator.
2. Preparation: cut the crop at four corners manually with the square of 3*3m, so
that the machine would operate and turn on the field. If the field ridge is too high
to place, cut off 2-3 rows of crop first.
3. Pay attention to the barriers including stub, numb, bricks, iron wire and deep pits
on the field, so as to avoid damaging the machine.
i)
Generally the machine enters the filed from the left corner, and harvest
clockwise.
ii) If the crop is fallen heavily, harvest manually. If the crop is fallen lightly,
harvest reversely. If the condition is limited, harvest in the vertical lodging
direction.
iii) If the field is wet, and the rubber wheels skid heavily, cancel the harvesting
process.
