KisanKraft
™
SELF PROPELLED REAPER
KK-SPR-1201P / 1202DV / 1203DH
: www.kisankraft.com
: +91.80.22178200
Page 19 of 72
split pin. It is available to adjust the length of the pulling line by adjusting the two
fixed nuts. Please fasten the two nuts after adjusting to the proper position.
3. Drive the chain and sprocket gear box connect. Pressure on the tension wheel,
and then fit with protective covers.
C. Installation of Engine:
Install the engine on the engine support and fix with 4 pieces of M10X45 hexagonal
bolts, which is not necessary to be fastened now. Then, install the v-belt, adjust the
engine to make two v-belt on the same level. Now, fasten the bolt, and press the
ground cable of the engine under the bolt.
D. Installation of Line Filter:
Install the high tube between the filter and the bent tube so that the engine could stay
away from the dust.
E. Installation of Belt Guard & Sprocket Guard
F. Install the light on the self-propelled body and make it with power supply.
G. Connect the pulling line of the accelerator and the speed adjuster
accordingly. Then the whole installation is completed
.
Before the no-load trial running, start up the engine by crank so as to observe the
running of the platform. Please start up the engine for no load trial running after
making sure it is normal.
Working
:
The operator should adjust and lubricate the machine properly so as to keep
the machine working normally, with the satisfactory performance, improved working
efficiency and longer service life.
Warning:
Please abide by the following regulations so as to avoid any accident.
Please stop running the engine on the flat area. Please check, adjust and clean
the parts after they stop running.
Please fix the wheel if parking the machine on the downhill.
Please put the removed security guard on the original position before starting up
the machine.
