KisanKraft
™
SELF PROPELLED REAPER
KK-SPR-1201P / 1202DV / 1203DH
: www.kisankraft.com
: +91.80.22178200
Page 24 of 72
TROUBLESHOOTING
Problem
Probable Cause
Remedy
The
conveying
is blocked
The upper & lower conveying
chains are lost or broken
Adjust the tension of the upper &
lower conveying chains.
The crop is too wet, with dew or
rain
Harvest after the crop is quite dry.
The pressing spring is loose
Adjust the thickness accordingly
The cutting knife digs the land.
Increase the cutting stubble
properly.
The crop falls heavily or
disorderly.
Have the single direction harvest or
cut part fallen crop manually
The crop is too short.
It should be not shorter than 35cm
The crop is too high and the crop
inclines on the conveying
Increase the cutting stubble
properly if the crop is higher than
1.2 m
The crop inclines on the
conveying when harvesting
Adjust the tension of the upper and
lower conveying chains and make it
consistent
The grain
lifter star
wheel
doesn’t
work
The tines of the star wheel are
broken
Replace the star wheel
The star wheel and the tines are
not meshing
Adjust them to make them meshing
The grain
lifter star
wheel
runs on
and off
The conveying chain belt is
broken, or the tines are lost
Repair the tines
The
conveying
chain
doesn’t
work.
The chain buckle is broken
Replace the chain buckle
The transmission sprocket of the
conveying chain is broken
Replace the sprocket
The
cutting
stubble is
uneven,
with the
laceration
The moving speed is too rapid
Adjust the accelerator
The cutting knife is blunt, or the
gap is too large
Repair or replace the cutting knife,
and adjust the gap accordingly.
The crop
is fallen
The cutting knife digs the land
Clean and increase the cutting
stubble accordingly
There’s one row left on the cutting
range
Add the knives for the missing row
Abnormal
noise
The bolt is loose
Check and fasten it
The lubricating part is lack of
lubricant
Check and add the lubricant.
