KisanKraft
™
SELF PROPELLED REAPER
KK-SPR-1201P / 1202DV / 1203DH
: www.kisankraft.com
: +91.80.22178200
Page 25 of 72
MAINTENANCE & STORAGE
Note
: It is required to add the oil and have the check on the flat field after stopping the
engine.
Maintenance
:
1. The cutting performance would be influenced if the knife is blunt or broken. It is
advised to grind or replace the knife.
2. If the gap in front of the knife is more than 1.5 mm because the knife presser is
warp resulted from the abrasion of the friction plate or the knife presser.
3. When the riveting of the fixed knives and the moving knives is loose, fasten them
accordingly.
4. If the knife is bent, it is necessary to shape or replace it.
5. If the grain lifter star wheel is worn or broken, which influence the grain lifting, it
should be replaced.
Up keeping:
It is necessary to lubricate the parts of the machine, which could be very helpful to
decrease the abrasion of the working parts, and to keep the machine in good condition, to
develop the working efficiency and to extend the service life. Before operation, the operator
should check whether the parts are lubricated. Do the lubrication as shown in the table
below.
Item
Lubricant
Lubricating type
Period
Chain & sprocket
Engine oil
Press adding
Each turn
Connecting
–
rod
bushing bearing
Butter
Press adding
Each turn
Other bearings &
bearing bases
Butter
Painting
Once in every
season
Gear case
Butter
Each season
Gear box
Engine oil
Each season
Knife presser, friction
plate
Engine oil
Brushing
2-4 hours
Note
: The gear box would not be added with oil on delivery. The users should add engine
oil after completing the installation.
Lubricate the parts according to the table given above.
Check the fasten pieces and riveting before operation, and repair or replace it accordingly.
Check the gap of the cutting knife and adjust accordingly.
Thoroughly clean the machine after operation
Storage:
After completing the working on one season, the machine should be stored for the next
season. Thus, the machine should be kept well as it’s a long period.
1. After completing the harvesting, it is required to unload the machine from the
tractor, clean it thoroughly and repair or replace the damaged parts.
2. Add enough lubricant on each adding point. The fixed knives and moving knives
should be painted with butter on the surface. In addition, the baffle of the cutting
platform and the grain-lifter cover should be painted with the antirust.
