Kingsman Marquis Infinite MQRB5143LP, Installation Instructions Manual

Page: 7 / 57

7
Installation and Operation
Installation Regulations
This gas appliance must be installed by a qualified installer in accordance with local building codes, or in the absence of
local codes, with the current CAN/CGA-B149.1 or .2 Installation Code (in Canada) or the current National Fuel Gas Code
Z223.1 when installed in the United States.
This appliance, when installed, must be electrically connected and grounded in accordance with local codes, or in the
absence of local codes, with the current CSA C22.1 Canadian Electrical Code or with the national Electrical Code;
ANSI/NFPA 70-1987 when installed in the United States.
Vertical Venting in Cold Climates
In cold climate conditions where temperatures go below -10 degrees Celsius or 14 degrees Fahrenheit, we
recommend that the chase be insulated and where the vent pipe enters into the attic space that the pipe be
wrapped with an insulated Mylar sleeve. This will increase the temperature of the vent and help the
appliance to vent properly in cold weather conditions.
It is also important in vertical vented direct vent appliances that the appliance be operated daily during the
winter months as this will help stop the termination from freezing up. We recommend using a thermostat set
at room temperature to allow the unit to cycle.
For Safe Installation and Operation of Your Gas Fireplace Please Note The Following:
1. This appliance gives off high temperatures and should be located out of heavy traffic areas and away from furniture
and draperies.
2. Children and adults should be alerted to the hazards of the high surface temperatures of this appliance and should
stay away to avoid burns or ignition of clothing.
3. Children should be carefully supervised when they are in the same room as your fireplace appliance.
NOTE:
It is recommended that a Carbon Monoxide (CO) detector be installed in or near bedrooms and on
all levels of your home. Place a detector about 15ft [4.5m] outside the room that houses your gas appliance.
Warning:
When purging the gas line, the glass front must be removed.
4. Never use your gas fireplace as a cooking device.
5. The Burner/Log Assembly has been engineered and permanently adjusted for proper flame control.
Do not alter the gas orifice.
6. Under no circumstances should this appliance be modified. Any parts that have to be removed for servicing should
be replaced prior to operating this appliance.
7. Installation and repair should be done by a qualified service person. The appliance should be inspected before use
and at least annually by a professional service person. More frequent cleaning may be required due to excessive
lint from carpeting, bedding material, etc. It is imperative that control compartments, burners and circulating air
passageways of the appliance be kept clean.
8. Control compartments, burners and air passages in this appliance should be kept clean and free of dust and lint.
Make sure that the gas valve and pilot light are turned off before you attempt to clean this unit.
9. The venting system (chimney) of this appliance should be inspected at least once a year and if needed, your
venting system should be cleaned.
10. Clothing or other flammable material should not be placed on or near the appliance. This appliance should not be
used as a drying rack for clothing nor should Christmas stockings or decorations be hung from it.
11. Under no circumstances should any solid fuels (wood, paper) be used in this appliance.
12. For safe operation, glass doors must be closed.