3-2 Operation Check
RC04-PCR-LA
in the PCR-LA AC Power Supply Operation Manual.
Note that performing a reset cancels all settings made thus far and
activates the Initial Setup Status.
Resetting Procedure Using the Remote Controller
1. Call the Home Position.
See the Home Position description given below.
2. Press the RESET (SHIFT, 6) key.
3. Verify that the ENTER LED blinks, activating ENTER wait
status.
4. Press the (SHIFT, ENTER) keys. This executes a reset.
• Home Position
The status in effect immediately after the POWER switch is
turned ON is called the Home Position (regardless of OUT-
PUT ON/OFF). To return to the Home Position from another
mode, press the ESC key.
• ENTER Wait
This is the condition in which the ENTER key has not yet
been pressed to initiate the operations performed thus far. In
this condition, the ENTER LED on the Remote Controller
blinks.
To cancel a operation before pressing the ENTER key, press
the ESC key.
ENTER Wait for this device has the same meaning as the
ENT Wait of the PCR-LA AC power supplies.
LCD (Liquid Crystal Display) Contrast Adjustment
To adjust the contrast of the Remote Controller LCD unit, use a small
screwdriver to turn the part shown in the
fi
gure. Adjust LCD contrast
to match lighting conditions at the operating location to obtain an
easy-to-see display.
Fig.3-1
Contrast Adjustment
DESCRIPTION
CONTRAST
Summary of Contents for RC04-PCR-LA
Page 10: ...1 4 General RC04 PCR LA...
Page 100: ...A 22 Appendix RC04 PCR LA...
