Kikusui PBZ20-20, User Manual, Page: 84 / 170

84
PBZ
Configuration (CONFIG)
List of CONFIG Settings
p. 86
The settings explained here are used to set the PBZ’s basic operation conditions and system
configuration. You can specify and view settings on the CONFIG screens. For detailed
information about each setting, see “CONFIG Setting Details”.
See
CONFIG- Setting Description
[1] MODE POLARITY Bipolar/unipolar mode
CONTROL CV/CC mode
RESPONSE VOLT Voltage response
CURR Current response
SENSING Remote sensing
[2] SIGNAL SOURCE SELECT Signal source
EXT SELECT External signal source
EXT GAIN External signal circuit gain
POWER ON STATE Power-on state
OUTPUT Power-on output state
SEQ RUN Power-on sequence execution
[3] SYNCHRONOUS OPERATION Synchronous operation
TRIGGER TRIG IN Polarity of the trigger signal input
TRIG OUT Polarity of the trigger signal output
EXT OUTPUT
ON/OFF POLARITY Contact signal logic to turn the output on
through external control
[4] MEMORY RECALL PRESET Method used to load preset memory
entries
KEY LOCK LEVEL The keys that are locked
BEEP Buzzer sound on or off
[5]
PARALLEL
1
1
The setting do not take effect until you restart the PBZ.
OPERATION Master or slave unit in parallel operation
UNIT Number of units in parallel operation
[6] ERR TRACE SCPI error display
INTERFACE TYPE
*1 Remote interface selection
GPIB
*1 ADDRESS GPIB address
RS232C
*1 BAUDRATE Baud rate
DATA BITS Data bits
STOP BITS Stop bits
PARITY BIT Parity bit
X-FLOW Flow control
USB VENDOR ID Vendor ID
PRODUCT ID Product ID
SERIALNo. Serial number
LAN
*1, 2
2
Only when the factory option LAN interface is installed.
DHCP DHCP feature
AUTO IP Automatic IP address assignment
STATUS LAN status display
IP ADDR IP address display
SUBNET Subnet mask display
MAC MAC address display
[7] MODEL INFO MODEL Model name display
SERIAL No. Serial number display
VERSION Firmware version display