Kikusui PBZ20-20, User Manual, Page: 158 / 170

158
PBZ
A
List of Factory Default Settings
Resetting the PBZ to its default values
If you hold down the SHIFT key while you turn the POWER switch on, the PBZ starts up with
the factory default settings. Continue holding down the SHIFT key until the initial screen is
displayed.
Operation mode and signal sources
Item Factory default
setting
Operation
mode CONTROL CV/CC mode CV
POLARITY Bipolar/unipolar mode BIPOLAR
Signal source
selection SELECT Internal, external, and addition INT
EXT SELECT External signal source BNC
External
signal input
(BNC
terminal) EXT GAIN Gain 0.0 (not inverted)
DC signal DC DC CV: 0.000 V
CC: 0.000 A
FINE Fine adjustment of the DC setting CV: 0.0000 V and
CC: 0.0000 A
SOFT START
SOFT STOP Soft start time
Soft stop time OFF
AC signal FUNC Waveform SIN (sine wave)
AMPL Amplitude CV: 0.0 Vp-p
CC: 0.0 Ap-p
FREQ Frequency 1000.00 Hz
PHASE Start phase 0 deg
DUTY Square wave duty cycle 50.0 %
AC AC signal: on/off OFF
SWEEP Frequency sweep: on/off OFF
MODE Sweep mode LINEAR
TIME Sweep time 1.0000 s
START Sweep start frequency 100.00 Hz
STOP Sweep stop frequency 1000.00 Hz
TRIG OUT TRIG OUT terminal: on/off OFF
MARKER FREQ Marker frequency 500.00 Hz
Response VOLT CV mode 3.5 µs
CURR CC mode (PBZ20-20) 35 µs
CC mode (PBZ40-10) 70 µs
Remote
sensing SENSING OFF