Kikusui PBZ20-20, User Manual

Page: 160 / 170

160
PBZ
List of Factory Default Settings
Setup memory
If you use to change settings to DEFAULT (the default values), memory is not
affected. If you reset the PBZ to its factory default settings, all the memory entries are cleared.
(This manual differentiates between the terms “default values
”
and “factory default settings.
”
)
Item Factory default
setting
1
1
The same for memory numbers 0 to 9. Each memory entry name is UNTITLED.
DC signal DC Voltage or current 0.000 V
FINE Fine adjustment of the DC setting 0.0000 V
SOFT START
SOFT STOP Soft start time
Soft stop time OFF
AC signal ON/OFF AC signal on/off state OFF
FUNC Waveform
Sine wave
AMPL Amplitude 0.0 V
FREQ Frequency 1000.00 Hz
PHASE Start phase 0 deg
DUTY Square wave duty cycle 50.0 %
AC signal
frequency
sweep SWEEP Whether sweeps are executed or not OFF
MODE Sweep mode LINEAR
TIME Sweep time 1.0000 s
START Start frequency 100.00 Hz
STOP Stop frequency 1000.00 Hz
TRIG OUT TRIG OUT terminal: on/off OFF
MARKER FREQ Marker frequency 500.00 Hz
Overvoltage
protection +V.LIM and +OVP Positive overvoltage protection activation
point
110 % of the rated
value
-V.LIM and -OVP Negative overvoltage protection activation
point 110 % of the rated
value
LIMIT / OVP Mode LIMIT
Overcurrent
protection +I.LIM and +OCP Positive overcurrent protection activation
point 110 % of the rated
value
-I.LIM and -OCP Negative overcurrent protection activation
point 110 % of the rated
value
LIMIT / OCP Mode LIMIT
The protective action that is carried
out when OVP or OCP is activated Power off or output off OUT OFF
Preset memory A, B, and C memory entries for CV mode
A, B, and C memory entries for CC mode
A, B, and C memory
entries for CV mode
MEASURE FUNC DC
APERTURE 0.1000 s
TRIG SOURCE AUTO
TRIG DELAY 0.00000 s
CONFIG
settings MODE
The same as the
CONFIG factory
default settings
p. 86
RESPONSE
SENSING
SIGNAL SOURCE
POWER ON
SYNCHRONOUS
TRIGGER SLOPE
EXT OUTPUT
ON/OFF
MEMORY
KEYLOCK
BEEP
PARALLEL
See
CONFIG