Kikusui PAT-T Series, Manual

Page: 58 / 158

Setup
Interface Setup
GPIB (Optional)
This interface valid only when the factory option GPIB interface board is installed.
GPIB connection
Use a standard IEEE488 cable to connect the PAT-T to the computer.
GPIB configuration
1.
Select GPIB (CF54: GPIb) in the CONFIG settings .
2.
Set the address (CF51: 1 to 30) in the CONFIG settings.
The address is set to 1 as factory default setting.
GPIB function
Function Subset Description
Source handshaking SH1 Full capability
Acceptor handshaking AH1 Full capability
Talker T6 Function available
Listener L4 Function available
Service request SR1 Full capability
Remote local RL1 Full capability
Parallel polling PP0 No capability
Device clear DC1 Full capability
Device trigger DT1 Full capability
Controller C0 No capability
Electrical interface E1 Open collector driver
Service request
Service request and serial polling functions are implemented.
>top
Overview
Introduction
Setup
Installing the VISA library
Interface Setup
Overview of Messages
Command Syntax
Parameters
Default settings
Command
(function search)
IEEE488.2 Common Commands
Output Setting
Protection and Clear the Alarm
System Configuration
Preset Memory Function
Setting Changes using triggers
Output On/Off Delay
Measurement
System
Register
Command
(ABC search)
A C F I M
O S T V *
Command
(Sub-system search)
SOURce
OUTPut
MEASure and FETCh
TRIGger
MEMory/ SENSe
SYSTem
STATus
IEEE488.2 Common Command
List (PDF)
Appendix
A List of Errors
Processing time of main
command
Tutorial
Turning the Power On and
Resetting the Instrument
Output programming
Using Triggers
Status Monitoring
Error Checking
Visual Basic 2008
PAT-T series Communication Interface Manual
KIKUSUI ELECTRONICS CORP. 58/158