Kikusui PAT-T Series, Manual

Page: 36 / 158

Command (Sub-system)
SYSTem subsystem
SYST:CONF:BTR Breaker trip.
SYST:CONF:BTR:PROT Turns breaker trip on/off when the OCP/OVP activates.
SYST:CONF:BTR:SHUT Turns the breaker trip on/off when the SD signal is applied.
SYST:CONF:PAR Setting the number of units in Master-Slave Parallel Operation.
SYST:CONF:PST Sets the status signal of the power on/off.
SYST:CONF:RSEN Queries the sensing switch status.
SYST:CONF:MSL Sets the status during parallel operation.
SYST:CONF:MPR Sets the output-on startup state. (Only on the PAT350-22.8T and
PAT850-9.4T)
SYST:CONF:SPH Sets the phase input mode (Three-phase input/Single-phase input
mode)
SYST:CONF:TRAC Sets whether to display or hide the communication error.
SYST:ERR Read the error information.
SYST:KLOC Panel operation lock.
SYST:LOC Sets to local.
SYST:OPT Queries the option interface board.
SYST:REM Sets the operation to remote. Locks the panel keys except the
LOCAL switch.
SYST:RWL Sets the operation to remote. Locks the panel operation.
SYST:VERS Queries the SCPI specification version with which the PAT-T
complies.
Overview
Introduction
Setup
Installing the VISA library
Interface Setup
Overview of Messages
Command Syntax
Parameters
Default settings
Command
(function search)
IEEE488.2 Common Commands
Output Setting
Protection and Clear the Alarm
System Configuration
Preset Memory Function
Setting Changes using triggers
Output On/Off Delay
Measurement
System
Register
Command
(ABC search)
A C F I M
O S T V *
Command
(Sub-system search)
SOURce
OUTPut
MEASure and FETCh
TRIGger
MEMory/ SENSe
SYSTem
STATus
IEEE488.2 Common Command
List (PDF)
Appendix
A List of Errors
Processing time of main
command
Tutorial
Turning the Power On and
Resetting the Instrument
Output programming
Using Triggers
Status Monitoring
Error Checking
Visual Basic 2008
PAT-T series Communication Interface Manual
KIKUSUI ELECTRONICS CORP. 36/158