Kikusui PAT-T Series, Manual

Page: 60 / 158

Setup
Interface Setup
LAN (Optional)
The LAN interface is a factory option.
To use the LAN interface to control the PAT-T, middleware that supports the VXI-11 protocol
must be installed on the controller. The middleware is installed automatically by the VISA
library.
There is
a Web browser interface to the PAT-T embedded in the LAN interface board. You
can configure the LAN interface settings from your PC's Web browser.
For information on topics such as connecting to your corporate LAN, your IP address, your
host name, and security, contact your network administrator.
LAN connection
Use a standard LAN cable (category 5 and straight) to connect the PAT-T to a network hub
or router. Use a crossover cable when making a direct connection.
LAN setting
Normally, you should set DHCP and AUTO IP to ON to set the IP address automatically.
1.
Select LAN (CF54 : LAn) by the CONFIG setting .
2.
Select DHCP (CF55 : On) by the CONFIG setting.
3.
Select AUTO IP (CF56 : On) by the CONFIG setting.
For direct connections, set DHCP(CF55) to OFF and AUTO IP(CF56) to ON and set the IP
address automatically. You cannot set the IP address from the panel. To set a fixed IP
address, first set the IP address automatically, and then set a fixed address by accessing the
PAT-T through a Web browser .
You can use thee CONFIG settings to check the IP address.
Parameter number Display Description
CF57 0 to 255 Display the 1st number of the IP address
CF58 0 to 255 Display the 2nd number of the IP address
CF59 0 to 255 Display the 3rd number of the IP address
CF60 0 to 255 Display the 4th number of the IP address
When you are going to use a fixed IP address over a long period of time or at intervals, we
recommend that you specify a host name. To set a host name, access the PAT-T through a
Web browser .
Warning
There are possible damage on the equipment or an electric shock. The LAN interface can be
accessed from any place on the network. Set the security when it is necessary. Security can be
set by the password protection and the host limitation by IP address.
->Setting procedure
NOTE
The LAN interface should be shifted remotely by the command unlike other interfaces. Set it by
the SCPI command " SYSTem:REMote " to the remote state. When you do a remote
programming, transmit this command to the front of the program.
Service request
Overview
Introduction
Setup
Installing the VISA library
Interface Setup
Overview of Messages
Command Syntax
Parameters
Default settings
Command
(function search)
IEEE488.2 Common Commands
Output Setting
Protection and Clear the Alarm
System Configuration
Preset Memory Function
Setting Changes using triggers
Output On/Off Delay
Measurement
System
Register
Command
(ABC search)
A C F I M
O S T V *
Command
(Sub-system search)
SOURce
OUTPut
MEASure and FETCh
TRIGger
MEMory/ SENSe
SYSTem
STATus
IEEE488.2 Common Command
List (PDF)
Appendix
A List of Errors
Processing time of main
command
Tutorial
Turning the Power On and
Resetting the Instrument
Output programming
Using Triggers
Status Monitoring
Error Checking
Visual Basic 2008
PAT-T series Communication Interface Manual
KIKUSUI ELECTRONICS CORP. 60/158