KFM2151
4-15
Remote Control
4.5.2
Channel Commands
■
<chan>
The logical channel number of the KFM2151 represents the unit number (0 to 4) in
the hundredths unit and the channel number (1 to 32) of the specified unit with the
lower two digits.
For example, the third channel of the master unit (unit number = 0) is 003 (or 3), and
the 32nd channel of the second unit (unit number = 1) is 132.
In this manual, the channel setting is denoted as <chan>.
Refer to the list below, and replace <chan> with the required setting.
<chan> is in the <NR1> form.
V
al
u
e:
Unit number 0
1 to 32 (001 to 032)
Unit number 1
101 to 132
Unit number 2
201 to 232
Unit number 3
301 to 332
Unit number 4
401 to 432
CHAN:VOLT:TERM
Specify the logical channel for voltage scanning and set the terminal and the
scanned source (on/off).
Command
CHANnel:VOLTage[:DC]:TERMinals
<chan>,<term+_NR1>,<term-_NR1>,{ON|OFF|1|0}
CHANnel:VOLTage[:DC]:TERMinals? <chan>
Parameter
<term+_NR1>, <term-_NR1>
V
al
u
e:
1 to 32
The lower two digits of the specified logical channel
by default.
Parameter
{ON|OFF|1|0}
V
al
u
e:
ON(1)
Scan the specified channel (default)
OFF(0)
Not scan the specified channel
The settings after sending *RST are indicated in Table 4-3.
Response
Returns TERM+ and TERM- of the specified logical channel and the scanned
source (on/off) in the <NR1>,<NR1>,<NR1> form in response to
CHAN:VOLT:TERM? <chan>.
(Example)
If channel 1 of unit number 0 is term+7 and term-8 and is set as a scanned
source, the following is returned in response to CHAN:VOLT:TERM? 1.
7,8,1
Summary of Contents for KFM2151
