3-
8
KFM2151
Operation
Setting the voltage channels
1.
Check that the KFM2151 is in monitor mode.
If the CHANNEL display or VOLT/TERM display is blinking, press the MON key.
2.
Press the IMP/
V
OLT key.
Select VOLT.
The IMP LED and VOLT LED illuminate alternately each time you press the IMP/
VOLT key.
3.
Press the SET key.
The CHANNEL display blinks.
The settings switch in order each time you press the SET key.
4.
Press the
and
keys or SHIFT+
and
keys to select the
channel.
5.
Press the SET key.
The VOLT/TERM display blinks.
6.
Press the
and
keys to select the scanned so
u
rce (O
N
/OFF).
7.
Press the SET key.
If you set the scanned source to ON in step step 6 , the OVP LED illuminates, and the
VOLT/TERM display blinks. If you select OFF, the CHANNEL display blinks.
If you set the scanned source to OFF, proceed to step step 14 .
8.
Press the
and
keys or SHIFT+
and
keys to set the
o
v
er
v
oltage protection (-2.00
V
to 200.00
V
).
9.
Press the SET key.
The UVP LED illuminates, and the VOLT/TERM display blinks.
10.
Press the
and
keys or SHIFT+
and
keys to set the
u
nder
v
oltage protection (-2.00
V
to 200.00
V
).
11.
Press the SET key.
The RANGE LED illuminates, and the VOLT/TERM display blinks.
12.
Press the
and
keys to select the range (2, 20, 200, or AUTO).
13.
Press the SET key.
The CHANNEL display blinks.
14.
To set other channels, repeat steps step 4 to 13 . To finish, press the
MO
N
key.
Summary of Contents for KFM2151
