90
Step 37: Attach Exit End Assembly to Fort
Note: When installing Pan Bolts make sure to look at
holes so bolts go through the side with the round recess
and the lock nuts go through the side with the hexagonal
recess. Keep all bolts loose until further step.
A:
Fit the Exit End Assembly to the last Elbow Assembly by
lining up the arrows on each assembly. Notice the elbow
orientation. (fig. 37.1)
B:
Place 1 TNR2 Slide Clamp Ring to the top of the joined
Assemblies, rotate counter clockwise 1 hole location then
attach with 3 (PB1) Pan Bolts (with LN1 lock nut) as shown in
fig. 37.1.
Use Quadrex Driver as a guide pin for each hole before
inserting bolt.
C:
Attach 1 TNR2 Slide Clamp Ring to the bottom of the
joined Assemblies using 3 (PB1) Pan Bolts (with LN1 lock nut)
as shown in fig. 37.2.
D:
Connect the 2 TNR2 Slide Clamp Rings together in 2 spots
using 1 (PB1) Pan Bolt (with lock nut) per hole. Make sure
seams and arrows line up and then tighten all bolts. (fig. 37.3).
Hardware
8 x
Pan Bolt
(LN1 lock nut)
PB1
Other Parts
2 x TNR2 Slide Clamp Ring
Bottom Slide Bolt Holes
After the clamp rings
are attached to the
elbows, fasten them
end to end with two
pan bolts and lock nuts
Elbow
Assembly
Top Slide Bolt Holes
Exit Elbow
Assembly
PB1
PB1
PB1
Fig. 37.1
Fig. 37.2
Fig. 37.3
LN1
LN1
LN1
Summary of Contents for Cedar Summit F29380
Page 15: ...15 9 mm mm Actual Size...
Page 119: ...119 NOTES...