49
Warning!
To prevent tipping and avoid potential injury, stakes
must be driven 13” (330mm) into ground. Digging or driving stakes can
be dangerous if you do not check first for under-ground wiring, cables
or gas lines.
A:
In the 6 places shown in fig. 15.1 drive the Rebar Ground Stakes 13” (330mm) into the ground against all 4
(2607) Diagonals and both (2613) Heavy SW Posts. Be careful not to hit the washer while hammering stakes into
the ground as this could cause the washer to break off.
B:
Attach ground stakes using 1 (S7) Pan Screw per ground stake. (fig. 15.2)
C:
After driving stakes into the ground, check for sharp edges caused by the impact of the hammer. Smooth any
sharp edges from impact area and touch up with outdoor paint.
Step 15: Install Ground Stakes
Hardware
6 x
Pan Screw
6 x Rebar Ground Stake
Other Parts
SEE FRONT COVER
FOR SAFETY CLEARANCE
Rebar
Ground
Stake
Fig. 15.1
Fig. 15.2
S7
2613
2607
Front
Swing Wall
13” In Ground
(330mm)
Swing Wall
2607
S7
Summary of Contents for Cedar Summit F29380
Page 15: ...15 9 mm mm Actual Size...
Page 119: ...119 NOTES...