Kidde Fire Systems ARIES NETLink, Installation, Operation And Maintenance Manual

Page: 96 / 294

Installation
February 2012 2-40 P/N 06-237058-001
2-8.9 City Tie Wiring
Refer to the wiring diagram shown below (Figure 2-33) for City Tie Card connections. Refer to
Section 2-7.2,
Inserting and Securing an Expansion Card for instructions on how to install the City
Tie Card.
Figure 2-33. City Tie Wiring Diagram
CAUTION
Any communications wiring which exits the building or facility should not be routed to or
located inside the same conduit as the AC power.
1. Only one output, Reverse Polarity, Local Energy or Shunt,
can be programmed to activate during alarm. Only one
output should be wired.
2. Maximum of one 12 AWG wire per terminal.
Installation Notes:
Not supervised.
Rated at 24 Vdc @ 100 mA
Reverse Polarity
Shunt
OUTPUTS:
1
1
2
2
3
3
4
4
End-of-Line Resisitor 5.1K, 0.5W
(supplied with City Tie Card)
Supervised for open circuit
and ground faults.
Rated at 24 Vdc @ 550 mA
City Tie Expansion Card
Local Energy J5
Manual Disconnect
Switch SW2
Reverse Polarity J7
Shunt J6
Position of Manual
Disconnect Switch:
TOP = Normal
BOTTOM = Disconnected
Not supervised
Rated at 24 Vdc @ 5.0A, resistive
The shunt connection is recognized only as a
supplementary signaling unit and is not recognized
as an auxiliary control unit connection per NFPA72.
Opens on
Alarm
Local Energy
S
1
2
3
4
End-of-Line
Resistor
S
Legend:
Supervised
S
TERMINAL STANDBY TROUBLE ALARM
1 +24VDC 0
RET 4 +24VDC 0
RET