Kidde Fire Systems ARIES NETLink, Installation, Operation And Maintenance Manual

Page: 135 / 294

Configuration and Programming
P/N 06-237058-001 3-23 February 2012
Figure 3-22. ARIES NET Link Set Menu Functions (Cont’d - Fig. 4 of 18)
FOOTNOTES (Figure 3-22):
12 Alarmline. Change the Configuration of an Addressable AlarmLine Module .
Purpose : To change one or more of the following Addressable AlarmLine Module (AAM) operating
characteristics for a single module or range of modules: pre-alarm and alarm thresholds as defined
by the module’s variable-threshold-setting switch; pre-alarm reporting; alarm or overheat reporting
Note: The AAM will create an “Overheat” message on the display if its alarm threshold is exceeded
and it is configured for overheat reporting. The control unit buzzer will also activate.
13 Remote Release. Configure a Remote Release .
Purpose : To change one or more of the following Remote Release Module (RRM) operating
characteristics for a single or range of modules: solenoid and actuator.
3. SET
3. SLC Devices
Cont’d
*
2. Configuration
4. Alarmline
Set AAM Configuration
Switch Setting 1 to 16 *__

Set AAM Configuration
Pre-Alarm 1: ON 2: OFF *

Set AAM Configuration
Alarm 1: Normal 2: Overheat *

5. Remote Release
Set AAM Configuration
ENTER SLC LOOP NUMBER (1-8)_

SLC Devices From *__ to ___

(1-255)
Set RRM Configuration
ENTER SLC LOOP NUMBER (1-8)_

SLC Devices From *__ to ___

(1-255)
*=
Level-2 (Installer) Password required .
12 13
Set RRM Configuration
1: Solenoid 2: Actuator *
