Figure
4
Rear Panel (Multiport Test Set)
Control Lines and Voltage Adjust
For further information pertaining to control lines and voltage adjustments see. Refer to
Test Set Interface
The Test Set Interface connector is used to send address and data to the Test Set from the PNA-X.
Pass Through Interface
The Pass Through Interface is used to connection to another test set.
Chassis Ground
A threaded terminal post for connecting the Test Set to a conductive object, cabinet or structure to
ensure a common potential and reduce leakage current in a system. Requires an English 1/4-20
thread nut (2950-0004) and lock washer (2190-0067).
Line Module
The line module contains the power cord receptacle. The line fuse, as well as a spare, reside within
the line module.
illustrates where the fuses are located and how to access
them.
Install the instrument so that the detachable power cord is readily identifiable and is easily reached
by the operator. The detachable power cord is the instrument disconnecting device. It disconnects
the mains circuits from the mains supply before other parts of the instrument. The front panel
switch is only a standby switch and is not a LINE switch. Alternatively, an externally installed switch
or circuit breaker (which is readily identifiable and is easily reached by the operator) may be used
as a disconnecting device.
Line Module Voltage Adjust
Chassis Ground
Control Line
Test Set Interface Pass Through Interface
13
Keysight U3024AH10 User's and Service Guide
Summary of Contents for U3024AH10
