Keysight Technologies N108 A Series, Getting Started

Page: 31 / 78

Installing Both N108xA and N1010A FlexDCA on a PC
2
N108xA-Series Getting Started 31
Step 13 (Optional). Connect to a Switching Test Set
1
Go to the Keysight Connection Expert, click on the switching test set listing as shown in Figure 25 .
2
Right click the SICL address and select copy.
Figure 25 Copy Switching Test Set’s SICL Address
3
Return to the compliance application:
4
In the compliance application’s Set Up tab, click the Switch Matrix Setup button that is located at the
bottom of the window.
5
In the Configure Switch Matrix Settings dialog box, select On which is located at the top of the dialog box
as shown in Figure 26 on page 32.
6
In the dialog box’s Controller tab, select Automatically select drivers and paths (limited models) .
7
In the Switch Drivers field, click the Models drop-down list to select Keysight U3020A S26 .
8
Click on the blank entry line shown in Figure 26 .
9
Click Connect to open the Connect to Keysight U3020A S26 dialog box.
NOTE
This section shows how to connect the optional Keysight U3020A S26 Switching Test Set. Connecting a BitifEye BIT
2100 would be similar.
NOTE
This button is only displayed if Switch Matrix is selected for the Multi-Lane Test Option field.