MY20K10 - 12_1.0_11.01.2021
38
Assembly
5.3
Commissioning
Only trained specialist staff may perform initial
commissioning since initial commissioning of the
S pedelec requires special tools and specialist
knowledge.
Experience has shown that a S pedelec which has
not yet been sold is automatically handed to
customers as soon as it appears ready to ride.
For this reason, every S pedelec must be
prepared, so it is fully ready for use
immediately after being assembled.
The assembly report (see Section
11.2
)
describes all safety-relevant inspections, tests
and maintenance tasks. All assembly work
must be completed to ensure the S pedelec is
ready to ride.
Complete an assembly report for quality
assurance purposes.
5.4
Preparing the battery
5.4.1
Checking the battery
The battery must be checked before it is charged
for the first time.
1
Press the
On-Off button (battery)
.
If none of the LEDs on the battery level
indicator light up, the battery may be damaged.
The battery may be fully charged if at least one,
but not all, of the LEDs on the battery level
indicator is lit up.
5.4.2
Retrofitting the PowerTube adapter
A PowerTube Adapter 400 and 500 needs to be
retrofitted to use a Bosch PowerTube 625 battery.
1
Use a TORX® T25 wrench to undo the screws
in the battery mount.
Figure 23: Undoing screws on battery mount
2
Use a ratchet to remove the two 4 mm hexagon
screws in the PowerTube adapter. If you don't
have a ratchet, you can use a hexagonal key to
remove the screws.
Figure 24: Removing the 4 mm hexagon screws
3
Use a ratchet to remove the two 4 mm hexagon
screws in the PowerTube adapter.
Figure 25: Removing hexagon screws
Burns from hot drive
The drive cooler can become extremely hot
during use. Touching it may cause burns.
Leave the drive unit to cool before assembly.
CAUTION
!
