Kernau KIGH 6422 CI B, Instruction Manual, Page: 47 / 108

EN
47
• Remember that the earth wire must not be interrupted by the circuit-breaker.
• The electrical connection may also be protected by a high sensitivity differential circuit- breaker.
You are strongly advised to fix the relative yellow-green earth wire to an efficient earthing system. Before
performing any service on the electrical part of the appliance, it must absolutely be disconnected from the
electrical network.
If the installation requires modifications to the home’s electrical system or if the socket is incompatible with the
appliance’s plug, have changes or replacements performed by professionally-qualified person. In particular,
this person must also make sure that the section of the wires of the socket is suitable for the power absorbed
by the appliance.
WARNINGS:
All our products are conform with the European Norms and relative amendments.
The product is therefore conform with the requirements of the European Directivesin force relating to:
• Compatibility electromagnetic (EMC).
• Electrical security (LVD).
• Restriction of use of certain hazardous substances (RoHS).
• EcoDesign (ERP).
FIG. 16
gas induction
TYPE AND SECTION OF THE POWER CABLES (see figure above).
TYPE OF
CABLE
MONOPHASE POWER
SUPPLY 220 - 240 V ~
Hob gas
B H05 RR-F 3x0,75mm
2
Hob induction A
H07 RN-F
H05 VV-F
3x1,5 mm
2
ATTENTION:
If the power supply cable is replaced, the installer should leave the ground
wire (B) longer than the phase conductors (fig. 24) and comply with the
recommendations given in paragraph 10.
WARNING:
In the need to disassemble the hob, first remove the screw on the bottom,
as shown in the figure beside!