Kernau KIGH 6422 CI B, Instruction Manual, Page: 46 / 108

EN
46
• This pipe must be installed so that it can not come into contact with moving parts of the built form
(eg drawers) and must not cross compartments that could be crammed.
It is advisable to apply the special adapter to the flexible pipe. This is easily available from the shops and
facilitates connection with the hose nipple of the pressure governor on the bottle.
WARNINGS:
• Remember that the gas inlet union on the appliance is a 1/2 gas parallel male type in compliance with
EN 10226 standards.
• The appliance complies with the provisions of the following EC Directives: 2016/426 regarding gas
safety.
ELECTRICAL CONNECTION
IMPORTANT:
The appliance must be installed following the manufacturer’s instructions. The manufacturer will not be liable
for injury to persons or animals or property damage caused by an incorrect installation.
The electrical connections of the appliance must be carried out in compliance with the provisions and standards
in force. Before connecting the appliance, check that:
• The voltage matches the value shown on the specification plate and the section of the wires of the
electrical system can support the load, which is also indicated on the specification plate.
• The electrical capacity of the mains supply and current sockets suit the maximum power rating of the
appliance (consult the data label applied to the underside of the cooktop).
• The socket or system has an efficient earth connection in compliance with the provisions and standards
in force. The manufacturer declines all responsibility for failing to comply with these provisions.
When the appliance is connected to the electricity main by a socket:
• Apply to the input cable “C”, if unprovided (see fig. 16) a normalized plug adequate to the load
indicated in the identification label. Connect the cables according to the scheme of fig.16 (60 cm.)
making sure to respect the undermentioned respondences (only for the two burners gas and induction
two elements):
Letter L (live) = brown wire
Letter N (neutral) = blue wire
Earth symbol = green - yellow wire
• The power supply cable must be positioned so that no part of it is able to reach an temperature of
90°C.
• Never use reductions, adapters of shunts for connection since these could create false contacts and
lead to dangerous overheating.
• The outlet must be accessible after the built-in.
When the appliance is connected straight to the electricity main:
• Install an omnipolar circuit-breaker between the appliance and the electricity main. This circuit-
breaker should be sized according to the load rating of the appliance and possess a minimum 3 mm
gap between its contacts.