Kernau KIGH 6422 CI B, Instruction Manual, Page: 35 / 108

EN
35
CHAPTER 3. USE
TRADITIONAL BURNERS
A diagram is screen-printed above each knob on the front panel. This diagram indicates to which burner the
knob in question corresponds.
After having opened the gas mains or gas bottle tap, light the burners as described below:
• Manual ignition:
Push and turn the knob corresponding to the required burner in an anticlockwise direction until it reaches the
full on position (large flame fig. 1), then place a lighted match near the burner.
• Automatic electrical ignition:
Push and turn the knob corresponding to the required burner in an anticlockwise direction until it reaches the
full on position (large flame fig. 1), then depress the knob.
• Lighting burners equipped with flame failure device:
The knobs of burners equipped with flame failure device must be turned in an anticlockwise direction until
they reach the full on position (large flame fig. 1) and come to a stop. Now depress the knob in question and
repeat the previously indicated operations. Keep the knob depressed for about 10 seconds once the burner has
ignited.
NOTE:
you are advise not to try and light a burner if the flame divider (Burner Cap) is not correctly place. In the
event of the Burner flames being accidentally extinguished, turn off the burner control and do not attempt to
re-ignite the burner for a least 1 minute
HOW TO USE THE BURNERS
Bear in mind the following indications in order to achieve maximum efficiency with the least possible gas
consumption:
FIG. 2
OFF
Full on position
Reduced rate
position FIG. 1
• Use adequate pans for each burner (consult the
following table and fig. 2).
• When the pan comes to the boil, set the knob to
the reduced rate position (small flame fig. 1).
• Always place a lid on the pans.
• Use only pan with a flat bottom and in thick
metal.
BURNERS POWER W Ø PAN CM
Double crown 5000 24 / 26
Rapid
2800 20 / 22
Auxiliary 1000 10 / 14