Kernau KIGH 6422 CI B, Instruction Manual, Page: 44 / 108

EN
44
FITTING THE HOB
The hob is equipped with a special seal to avoid any infiltration of liquid into the unit. To apply this seal
correctly, please follow the instructions given below carefully:
• Remove all the mobile parts of the hob.
• Turn the hob upside down and place the adhesive putty “E” (fig.
14) under the edge of the hob so that perfectly matches the outer
perimeter edge of the glass. The ends of the strips must match
without overlapping.
• Stick the putty to the glass evenly and securely, using your fingers
to press it into place.
• For the gas: fix the hob with the proper hooks “S” and fit the
prominent part into the porthole “H” on the bottom; turn the
screw “F” until the hook “S” stick on the top (fig. 15).
• For the induction: position the hob in the hole in the unit and
fasten it in place using the appropriate screws “F” of the fastening
hooks “G” (see fig. 15/A).
• In order to avoid accidental contact with the surface of the box of
the overheated hob during use, it is necessary to install a wooden
divider at a minimum distance of 120 mm from the top, fastening
it in place with screws (fig. 12).
CAUTION:
In case of hotplate glass breakage:
• Shut immediately off all burners and any electrical heating element and isolate the appliance from the
power supply.
• Do not touch the appliance surface
• Do not use the appliance.
POSITIONING HOOKS
FIG. 14
gas induction
hook A (gas) hook B (induction)
FIG. 15/A
FIG. 15