Kernau KIGH 6422 CI B, Instruction Manual, Page: 41 / 108

EN
41
CHAPTER 4. CLEANING
IMPORTANT:
Always disconnect the appliance from the gas and electricity mains before carrying out any cleaning operation.
CERAMIC WORKTOP
It is very important to clean the hob every time you use it,
while the glass is still warm.
Do not clean using abrasive metal scourers, powder
abrasives or corrosive sprays. Periodically wash the hot
plate, the pan support, the enamelled burner caps “A”, “B”
and “C” and the burner heads „T” (see fig. 8/A - 8/B) with
lukewarm soapy water.
They should also be cleaned plugs „AC” and flame detection
„TC” (see fig. 8/B).
Clean them gently with a small nylon brush as shown (see
fig. 8) and allow to dry fully.
Do not wash in the dishwasher.
Following this, all parts should be thoroughly rinsed and
dried. Never wash them while they are still warm and never
use abrasive powders. h.
WARNINGS:
Comply with the following instructions, before remounting
the parts:
• Check that burner head slots “T” (fig. 8/A) have not
become clogged by foreign bodies.
• Check that enamelled burner cap “A”, “B” and “C”
(fig. 8/A - 8/B) have correctly positioned on the
burner head. It must be steady.
• The exact position of the pan support is established
by the rounded corners, which should be set towards
the side edge of the cooktop.
• Do not force the taps if they are difficult open or
close. Contact the technical assistance service for
repairs.
• Don’t use steam jets for the equipment cleaning.
NOTE:
Continuous use could cause the burners to change colour due to the high temperature.
FIG. 8
FIG. 8/B
FIG. 8/A