KEPCO KLP 10-150-2, User Manual

Page: 85 / 92

KLP 070312
4-7
increase and the “–“to decrease the output voltage until the DVM reads as close as possible
to minimum rated POSITIVE voltage.
FIGURE 4-2. VOLTAGE CALIBRATION WINDOW
2. Click the Press to ACCEPT button to accept the value. The status display then reads
VMAX . Monitor DVM and click the “+” button to increase and the “–“ to decrease the output
voltage until the DVM reads as close as possible to maximum rated voltage.
3. Click the Press to ACCEPT button to accept the value; the status display now reads OUTV .
At the ANALOG I/O PORT J2, connect the DVM (M– to pin 13, M+ to pin 6) and the d-c
power source (V– to pin 9, V+ to pin 3); set the d-c source output to 10.00V. Click the “+” but-
ton to increase and the “–“ button to decrease the output voltage until the DVM reads as
close as possible to 10V.
4. Click the Press to ACCEPT button to accept the value. The status display will not change.
At the calibration window, click the CURRENT Button to proceed to current calibration (see
PAR. 4.4.2) .
4.4.2 CURRENT CALIBRATION (VXI plug&play DEMO)
During current calibration, the current, current readback and analog current readback are cali-
brated.