KEPCO KLP 10-150-2, User Manual

Page: 60 / 92

3-20
KLP070312
FIGURE 3-2. FAULT RECOVERY CONFIGURATION DISPLAY
2. To change a fault recovery setting, tap the DC OUTPUT switch to enter the Recovery menu.
3. The status display shows
PASS
. Enter the unit password (see PAR. 3.2.7) and tap DC OUT-
PUT switch to accept the number. When the password is accepted, status display reads
OVP
and the DC VOLTS display shows the present fault recovery status (
PROT
or
SAFE
) for
OVP
.
Rotate either VOLTAGE or CURRENT control to cycle through
OVP
,
OCP
,
OLF
,
TEMP
, and
PWR
settings. To exit tap the DC OUTPUT switch while the status display shows
RTN
.
4. To change a setting, tap the DC OUTPUT switch while the status display shows the fault.
The setting in the DC VOLTS display begins to blink. Rotate either VOLTAGE or CURRENT
control to cycle through the allowable settings. Tap the DC OUTPUT switch to accept the
setting shown in the DC VOLTS display.
5. To continue, rotate either VOLTAGE or CURRENT control to select another fault. To exit,
either select
RTN
and tap the DC OUTPUT switch to go to the next highest menu, or tap the
FUNCTION switch to exit function mode.
3.2.16.4 ANALOG OUTPUT FULL SCALE CALIBRATION
Enter
UTIL
menu (see PAR. 3.2.16, steps 1 through 3) and rotate either VOLTAGE or CUR-
RENT control until status display reads
ANRB
.
• The DC VOLTS display shows the analog readback voltage value that produces the full
scale output voltage as established by the virtual model.
• The DC AMPS display shows the analog readback voltage value that produces the full
scale output current as established by the virtual model.
1. To change the settings tap the DC OUTPUT switch. Note that DC VOLTS and DC
AMPERES displays begin blinking.
2. Rotate VOLTAGE control to set the analog readback voltage value desired for full scale out-
put voltage.
3. Rotate the CURRENT control to set the analog readback voltage value desired for full scale
output current.
4. Tap the DC OUTPUT switch to accept the new settings (blinking stops) or use a thin tool
(e.g., a paper clip) to press the FUNCTION switch to cancel the operation.
5. To exit, rotate either VOLTAGE or CURRENT control until the status display reads
RTN
, then
tap the DC OUTPUT switch. To exit the
UTIL
menu rotate either VOLTAGE or CURRENT
control until the status display reads
EXIT
, then tap the DC OUTPUT switch.
NOTE:
THE FOLLOWING SETTINGS ARE SHOWN:
PWR SET TO AUTO
TEMP SET TO AUTO
OLF SET TO PROTECT
OCP SET TO PROTECT
OVP SET TO SAFE