Kenwood TS-990S, Instruction Manual

Page: 179 / 290

9-11
TRANSMIT FUNCTIONS 9
Index Contents
target frequency to be adjusted.
6 Press [-] (F5) or [+] (F6), or rotate the MULTI/CH
control to select the level for each frequency band.
Press and hold [(RESET)] (F2) to revert all frequency levels
to their defaults.
7 Press [ESC], or press and hold [TXEQ/SEL] to exit.
Press [ ] (F1) to revert to the TX Equalizer screen.
Note:
◆ The configurations for other frequency characteristics than User 1
to User 3
COPYING THE CONFIGURATION DATA FOR THE TX
DSP EQUALIZER
After adjust the TX Equalizer according to your preference,
you can copy and save the configuration data as the user.
1 Press and hold [TXEQ/SEL] to open the
TX Equalizer
screen.
2 Press [ ] (F2) or [ ] (F3), or rotate the
MULTI/CH control to select the desired characteristics
of the speech processor.
3 Press [COPY] (F5) to copy the configuration data.
A message notifying you about how to specify the destination of
the copied configuration data appears.
4 Press [USER1] (F2), [USER2] (F3), or [USER3] (F4)
to specify the target to copy the configuration data.
• The data copying the configurations for TX DSP equalizer
is complete and the TX Equalizer screen reappears.
• Pressing [CANCEL] (F7) reverts to the TX Equalizer
screen without reading the configuration data.
In the following procedure, you can edit and copy the
configuration data for TX DSP equalizer.
1 Press and hold [TXEQ/SEL] to open the
TX Equalizer
screen.
2 Press [ ] (F2) or [ ] (F3), or rotate the
MULTI/CH control to select the desired characteristics
of the speech processor.
3 Press [ADJ] (F4) to open the TX Equalizer screen.
For the adjustment of the TX DSP equalizer, refer to
"ADJUSTING THE TX DSP EQUALIZER". {page 9-10}
4 Press [COPY] (F7) to start a copy.
A message prompting you to ensure the destination of the
copy appears.
5 Press [USER1] (F2), [USER2] (F3), or [USER3] (F4)
to specify the target to copy the configuration data.
• The data copying the configurations for TX DSP equalizer
is complete and the TX Equalizer screen reappears.
• Pressing [CANCEL] (F7) returns you to the TX Equalizer
screen without copying the configuration data.
SAVING THE CONFIGURATION DATA FOR THE TX DSP
EQUALIZER
You can write the configuration data for the TX DSP
equalizer onto a USB flash drive.
REV
[F1]~[F7]
[TXEQ/SEL]
[ESC]
[MULTI/CH]
[USB]
1 Press and hold [TXEQ/SEL] to open the TX Equalizer
screen.
2 Insert a USB flash drive, which has been formatted by
the transceiver, into the (USB-A) connector.
After the USB flash drive has been correctly recognized,
" " appears on the main screen.
3 Press [ ] (F2) or [ ] (F3), or rotate the
MULTI/CH control to select the desired characteristics
of the speech processor.
4 Press [SAVE] (F7) to save the configuration data.