Kenwood TS-990S, Instruction Manual

Page: 162 / 290

7-8
7 BANDSCOPE
Index Contents
CHANGING THE ATTENUATOR FOR THE
BANDSCOPE
If the target signal cannot easily be distinguished on the
Bandscope screen due to excessive input signal even
after the adjustment of the reference level, change the
attenuator for the bandscope to attenuate the bandscope
input level.
1 Press [ATT] (F5) to select an attenuator.
• Each time you press [ATT] (F5), the level cycles as follows:
Off > 10 dB > 20 dB > 30 dB. The attenuated value appears
on the upper right side of the grid.
• Pressing and holding [ATT] (F5) cycles through the
attenuation in the reversed sequence.
• The default is "Off".
• If [ATT] (F5) is unavailable in the key guide, press [MORE]
(F1).
Note:
◆ Changing of the attenuation for the bandscope does not influence
the receive sensitivity.
DISPLAYING THE TRANSMISSION SIGNAL
WAVEFORM
While transmitting with the bandscope displayed in
Center mode, you can select whether or not to display the
waveform of the transmit signal.
1 Select Group No. 8, "Bandscope", from the Menu
screen.
2 Access Menu 00, "Bandscope Display during TX".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5) to select either "On" or "Off"
from the parameter box.
The default is "Off".
5 Press [ ] (F1).
6 Press [MENU] to exit.
Note:
◆ In Fixed mode, the transmission signal waveform cannot be
displayed.