
NX-900
5
REALIGNMENT
1. Modes
User mode
Panel test mode
Firmware version information
Panel tuning mode
Data programming mode
PC test mode
PC tuning mode
PC mode
Clone mode
Firmware
programming mode
Mode
Function
User mode
For normal use.
Panel test mode
Used by the dealer to check the fundamen-
tal characteristics.
Panel tuning mode
Used by the dealer to tune the transceiver.
PC mode
Used for communication between the trans-
ceiver and PC.
Data programming
mode
Used to read and write frequency data and
other features to and from the transceiver.
PC test mode
Used to check the transceiver using the PC.
This feature is included in the FPU.
PC tuning mode
Used to tune the transceiver using the PC.
This feature is included in the FPU.
Firmware program-
ming mode
Used when changing the main program of
the fl ash memory.
Clone mode
Used to transfer programming data from
one transceiver to another.
Firmware version
information
Used to confi rm the internal fi rmware ver-
sion.
2. How to Enter Each Mode
Mode
Operation
User mode
Power ON
Panel test mode
[ ] + Power ON
PC mode
Received commands from PC
Panel tuning mode
[Panel test mode] + [ ]
Firmware programming mode
[ ] + Power ON
Clone mode
[ ] + Power ON
Firmware version information
[ ] + Power ON
3. Panel Test Mode
Setting method refer to ADJUSTMENT.
4. Panel Tuning Mode
Setting method refer to ADJUSTMENT.
5. PC Mode
5-1. Preface
The transceiver is programmed by using a personal com-
puter, programming interface (KPG-46/46A) and program-
ming software (KPG-111D: ver. 2.30 or later).
The programming software can be used with a PC. Fig-
ure 1 shows the setup of a PC for programming.
KPG-111D
(ver. 2.30 or later)
PC
KPG-46 or KPG-46A or
KPG-46A + KCT-53U +
Tuning cable
(E30-3383-05)
KPG-46
Transceiver
PC
D-SUB
(25-pin)
Transceiver
PC
KPG-46A
D-SUB
(9-pin)
Transceiver
PC
KPG-46A
KCT-53U
USB
Fig. 1
5-2. Connection procedure
1. Connect the transceiver to the computer using the inter-
face cable and USB adapter (When the interface cable is
KPG-46A, the KCT-53U can be used.).
Note:
• You must install the KCT-53U driver in the computer to
use the USB adapter (KCT-53U).
• When using the USB adapter (KCT-53U) for the fi rst time,
plug the KCT-53U into a USB port on the computer with
the computer power ON.
2. When the POWER switch on, user mode can be entered
immediately. When PC sends command the transceiver
enter PC mode, and “PROGRAM” is displayed on the
LCD.
When data transmitting from transceiver, the red LED is
lights.
When data receiving to transceiver, the green LED is
lights.
Note:
The data stored in the computer must match the “Model
Name” when it is written into the fl ash memory.
Summary of Contents for NEXEDGE NX-900
Page 105: ...NX 900 105 MEMO ...
Page 106: ...NX 900 106 MEMO ...