KCH-16
14
INSTALLATION
1. Transceiver (TK-5710/5710H/5810/5810H)
The KRK-16 Handheld control head is used to remotely
operate the transceiver (TK-5710/5710H/5810/5810H).
■
Using the transceiver with one KCH-16
(For use with a single head)
1-1. Installing the KRK-11 Panel assembly onto the
transceiver
1. Remove the upper and lower cases of the transceiver.
2. Insert the lead wire with connector (W700) from the
transceiver control unit (X53-412) to the connector (CN4)
of the KRK-11 Panel assembly.
3. Install the KRK-11 Panel assembly onto the transceiver
using four screws (
q
).
Note:
Take care that the lead wire with connector (W700) is not
caught when fi tting the KRK-11 Panel assembly onto the
transceiver.
Transceiver
Packing
W700
CN4
KRK-11
Panel assembly
:
:
Fig. 1-1-1
4. Affi xing the sheet (G11-4379-04) for waterproofi ng (Fig.
1-1-2).
(1) Remove the cover paper from the sheet (
w
).
(2)
Affi x the sheet while taking note of the position of the
three parts as shown in Fig.1-1-2 (
e
).
Firmly affi x the sheet to the chassis by pushing the
double-coated tape with your fi ngers.
(3)
Repeat step (2) to affi x the sheet to the other side of
chassis.
Note:
The sheet cannot be reused. Affix a new sheet when
you removed the sheet.
5. Reassemble the upper case and lower case of the trans-
ceiver. (Refer to the TK-5710(B)/5710H(B) service manual
(B51-8727-10) (pages 25 and 26) or the TK-5810(B) ser-
vice manual (B51-8780-00) (page 23).)
Note:
Take care that the sheet (G11-4379-04) does not peel off
when installing the upper/lower case.
Affix the sheet
while taking note of the
position of the three parts.
@
.
KRK-11 Panel assembly
Fig. 1-1-2
1-2. Connecting the KRK-11 Panel assembly and
Interface box using the KCT-22 control cable
1. Insert one connector of the control cable to the trans-
ceiver (with KRK-11 Panel assembly) and the other to the
KRK-11 Interface box.
Connect each GND cable with each GND terminal of the
KRK-11 Panel assembly and KRK-11 Interface box using
the screw (
q
) supplied with the control cable.
2. Secure the one connector of the control cable to the
KRK-11 Panel assembly using two screws (
w
) according
to the installation condition of the transceiver.
3. Secure the control cable to the KRK-11 Panel assembly
with the cable fi tting (J21-4354-04) and the two screws
(
e
) supplied with the KRK-11.
4. Secure the other connector of the control cable to the
KRK-11 Interface box using two screws (
r
) in the same
way.
A
B
C
1
0
2
S
5
8
4
9
7
3
6
Transceiver
KCT-22
Control cable
KRK-11
Interface box
Cable
fitting
GND
KCH-16
J2
GND
KRK-11
Panel assembly
:
;
:
@
.
Fig. 1-2
