Kenwood HMP54, Instructions Manual

Page: 8 / 150

4
Before using your Handmixer for the
first time
O
Wash the parts (see ‘Cleaning’).
Key
1
Speed & Pulse selector
2
Tool SureEject™
3
Mixer
4
Beater
5
Beater with gear
6
Kneader
7
Kneader with gear
8
Mixing bowl
9
Cradle
10
Mixer release button
11
Cradle release lever
12
Stand
13
Splashguard
To Use your Handmixer
Fitting the Beaters/Kneaders
Refer to illustration
A
Insert the beater/kneader with the
plastic gear in the
socket.
Setting Up the Bowl & Stand
Refer to illustration
A
–
F
1 Fit the beaters/kneaders to the
Handmixer.
2 Hold the front of the cradle and
raise by pressing the cradle release
lever.
3 Place the bowl onto the stand.
4 Fit the mixer to the cradle and push
down to secure.
Note: Check that the beater/
kneader with the plastic gear aligns
with the drive gear on the cradle.
5 Add the ingredients, then lower the
cradle by holding the Handmixer
handle whilst pressing the cradle
release lever at the same time.
6 Plug in and select a speed (Refer to
the recommend usage chart).
Pulse
Slide the speed selector to the (P)
position to use in short bursts at
maximum speed. Note: the motor will
only operate for as long as the control
is held in position.
Splashguard
Fit the splashguard if required
E
.
After Use
Refer to illustration
G
–
I
1 Switch the speed selector to the ‘O’
OFF position.
2 Hold by the handle and lift up the
cradle by pressing the cradle release
lever.
3 Remove the mixer from the cradle by
pressing the mixer release button and
lifting off.
4 Slide the tool SureEject™ down to
release the tools.
Note: The tools can only be removed
when the speed selector is in the ‘O’
OFF position.
Note: When ejecting the tools hold the
hand mixer over the bowl.
Cord Storage J
Wrap the cord round the heel of the
handmixer. Then store on the stand.