Mechanical installation
INTORQ | BA 14.0222 | 06/2020
18
5
Mechanical installation
This chapter provides step-by-step instructions for the installation.
Important notes
NOTICE
The toothed hub and screws must not be lubricated with grease or oil.
5.1
Design of end shield and shaft
¾
Comply with the specified minimum requirements regarding the end shield and the shaft to ensure a
correct function of the brake.
¾
The diameter of the shaft shoulder must not be greater than the tooth root diameter of the hub.
¾
The form and position tolerances apply only to the materials mentioned. Consult with INTORQ before
using other materials; INTORQ's written confirmation is required for such usage.
¾
The brake is screwed on at the rear; the bearing is usually used for the support. Make sure that the
screws are tightened evenly all round to prevent the brake from tilting. Use a torque wrench according
to DIN.
¾
Keep the end shield free from grease or oil.
5.2
Tools
Size
Torque wrench
DIN EN ISO 6789 / Type 2
Insert for
hexagonal socket (Allen) screws
Multimeter
Measuring range
Wrench width
[Nm]
[mm]
80
1 to 12
4
100
4
5.3
Preparing the installation
1. Remove the packaging from the spring-applied brake and dispose of it properly.
2. Check the delivery for completeness.
3. Check the name plate specifications (especially rated voltage)!
