©
www.kemper-olpe.de
– 09.2019 / K410068602023-00 –
33
/
52
Electrical installation
3.3
3
Installation | Assembly
3.1
Prerequisite for
installation
Installation note
3.2
Ethernet network
Installation
3.4
•
These installation and operating instruc-
tions (included in the scope of supply)
•
Computer with
a) web browser installed
b) PDF reader installed
Network cable
•
IP configuration specified for the relevant
parameters by the network and BACnet
coordinator for tie-in to your network,
see Section 5 Check list.
The gateway is fitted with a bracket for at-
tachment to a TS35 DIN top hat rail as per
EN 60715.
Connect the gateway using a voltage supply
that is approved as per the technical specifi-
cations contained in these instructions.
Warranty is excluded if the gateway is con-
nected to an unsuitable voltage supply or the
housing is opened.
Do not connect to a network un-
less the gateway has been com-
pletely configured.
Once configuration is complete, connect the
Ethernet network cable (RJ-45 connection) to
the gateway and the network.
Use a CAT5 (or comparable) cable.
Avoid parallel installation to pow-
er cables (e.g. to engines, frequen-
cy converters, etc.)
MASTER 2.0|2.1
IP address:
10.1.23.150
Subnet mask:
255.255.255.0
Modbus client
IP address:
10.1.23.151
BACnet gate-
way
IP address:
10.1.23.151
Subnet mask:
255.255.255.0
The IP addresses on the MASTER 2.0|2.1 and
BACnet gateway are preset.
Pre-configured network
settings
3.5
In the event of a reset, the preset
IP address on the gateway will be
reset to the basic setting:
IP 169.254.0.1.
