Section 3: Equipment startup
S535 Wafer Acceptance Test System Administrative Guide
3-2
S535-924-01 Rev. B / January 2019
Figure 35: S535 power distribution unit (PDU) circuit breaker
2.
Press the power/standby button on the computer and monitor.
3.
Set the power button on the front door of the system cabinet to the ON position.
Figure 36: S535 power ON switch
System startup
To start up the system:
1.
Make sure that the power switch on each of the power distribution units (PDUs) is set to ON.
2.
Set the power button on the front door of the system cabinet to the ON position.
3.
If the computer has not started to boot, open the front cabinet door and press the power/standby
switch on the host computer.
4.
Wait for all of the instruments to power up.
5.
Log onto your computer.
