KDS-7XII Radio Remote Control System
-23-
slot, K-7XII will switch to PPM status automatically and you will see following screen.
Figure 28 – PPM status
Notice:
when the transmitter is in PPM status, the RF module will stop working, and then the
receiver will lost signal if it was power on.
17 Change Transmit Frequency
Electric interference may exist when using remote controller system. If it interferes with the
frequency of your system, your devices will be out of control. Under these circumstances, you
can try to change the transmitter frequency by following steps:
1
．
Enter system mode by holding MENU and turning on transmitter
2
．
Press MENU several times to "ID GEN" function, you can see following screen
3
．
Press UP or DN to change the option to 'YES'
4
．
Press + or - to confirm the operation
5
．
The transmitter will regenerate the frequency and ID, and then the display will show 'OK'
and the transmitter will return to 'NO' status automatically.
Figure 29 – ID GEN menu
Notice:
1
．
The new frequency and ID are selected randomly. If the interference still exists, you can try
to change it again until the interference disappears.
2
．
After the frequency changing, please rebind the radio.
Notification
Summary of Contents for KDS-7XII
Page 1: ......
