KDS-7XII Radio Remote Control System
-22-
14 Countdown Timer for Throttle
K-7XII has a countdown timer relate to throttle. When in normal using status, you can see the
timer on the center of screen. The default value is five minutes, like Figure 26. You can press INC
or DEC to change the value. The max value is 99 minutes.
When you push throttle stick up, the timer will run from the value you set to zero. When at the last
1 minute remaining, the transmitter will beep to notify you.
Figure 26 - Throttle countdown timer
15 No Control Protection
K-7XII supports 'No Control Protection' function. You can predefine a set of values for each
channel. The receiver will use these values if it loses signal from transmitter.
To set the values, you should do as following steps:
1) Turn on the transmitter and receiver, bind them.
2) Adjust the transmitter, and make all channels to the position as you expect.
3) Hold ESC button until the screen of transmitter will display 'NCP' like Figure 27, and the
RF LED shines, and the LED of receiver will go out at the same time.
4) After 1 second, the transmitter and the receiver will restore to normal status, the defining
of ' No Control Protection ' is done.
Figure 27 - No Control Protection setting
16 Using PPM Signal
There is a PPM signal output slot at bottom of K-7XII. When you plug the signal line into the
Throttle timer
Notification
Summary of Contents for KDS-7XII
Page 1: ......
