KBL megaSun 5600, Operating And Maintenance

Page: 24 / 56

24
Step Procedure Reference
1 Canopy:
Open the canopy pane and tilt it downwards. Section 5.2
2 Remove the tanning tubes 5 and 6. Now you can
replace the tube.
3 Re-install the tanning tubes and close the canopy.
4 Lateral pane:
Open the lateral pane and remove the two upper
tanning tubes. Now you can replace the tube. Section 5.2
5 Re-install the tanning tubes and close the lateral pane.
Step Procedure Reference
1 Undo the two screws of the base pane and tilt the
pane upwards.
2 Unscrew the protective conduit on both sides and
push it to the right (or to the left). Now you can replace
the tube. Illustr. 5-14
3 Close the base pane.
Operation and Service KBL 5600
5.7 Unit lighting
Coloured " lter
Replacing the
lighting system in
the canopy
The coloured fi lter has to replaced at the latest when replacing
the tanning tubes.
Both in the canopy and in the lateral section, there is a coloured
lighting tube installed behind the tanning tubes. (see Table).
Replacing the
unit lighting in the
lower front section
The tube in the lower front section is located in a protective
conduit, which has been screwed onto the tube sockets. Take
the opportunity to check the filter mat and to clean or replace it if
necessary.
Illustr. 5-14 Unit lighting in the
lower front section and the starter
for this tube on the left side.