2
OPERATING INSTRUCTIONS
MINIDUMPER
CARRY 110
16
2.7.7 INSTALLING THE SELF-LOADING SHOVEL (OPTIONAL)
A
L.1500
E
L.930
F
L.2550
E
D
A
D
C
B
L.2200
1
Fit the T fittings (ref. A) to the cylinders. RH cylinder with base connector fitting, LH cylinder with head connector
fitting.
2
Fit the steel bushes (ref. B) to the skip and fit the grease fitting (ref. C).
WARNING, use appropriate tools to fit the bushes.
WARNING, do not use hammers or other blunt instruments; the mounts welded to the skip could be deformed, thus
preventing assembly.
3
Fit the shovel arms to the skip using the hex head pins (ref. D). Fully tighten down the pin locknut.
4
Mount the cylinders to the arms (RH cylinder to RH arm, etc) using the provided hex head pins (ref. D) and fully
tighten down the pin locknut.
5
Fit the hydraulic lines to the cylinders in accordance with their length. Route the two L=930 and L=1500 lines into
the rear guide (ref. F) welded under the skip. Route the hydraulic lines L=2200 mm and L=2550 mm into the guides
on the skip; now fit the female snap fittings to the ends of both with their seal washers.
6
Mount the cylinders to the skip using the bolts (ref. E) and locknuts. DO NOT TIGHTEN the nuts down; the cylinder
must be free to rotate.
7
Fit the shovel taking care that it is tightly mounted to the arms.
8
Secure the L=2200 and L=2550 lines to the linkage frame with their brackets.
9
Connect the lines to the machine’s PTO using the snap fittings.
Summary of Contents for CARRY 110
Page 2: ......
Page 49: ...TRACKED MINIDUMPER CARRY 110 PUBLISHED MARCH 2017 KATO IMER S p A ITALY ...
Page 50: ......
Page 51: ......