2
OPERATING INSTRUCTIONS
MINIDUMPER
CARRY 110
15
2.7.4 CEMENT MIXER KIT
The cement mixer kit is composed of a 350 L mixing tank driven by a hydraulic motor. It is suited to mixing construction
conglomerates, concrete and cement; composite earths and similar materials in greenhouses; foodstuffs and so on in
agriculture.
For even mixing, the tank should be run at 24/25 rpm. Set the speed with the engine speed adjustment or with the
standard valve.
The cement mixer kit can only be mounted to machines with the AUXILIARY PTO.
This accessory is particularly versatile due to the possibility of loading at a defined station, mixing while on the move and
unloading even at a distant location.
To unload, proceed as explained in point 2-1-4.
It combines with a special self-loading shovel.
Be careful to position the shovel properly when unloading. Move the shovel to the fully up position to avoid interfering
with the tank.
To load with the shovel, use the “shovel control lever” near to the operator handle and proceed as follows:
•
Lower the shovel to the ground
•
Move the machine closer to the heap slowly, until the shovel is completely full
•
Raise the shovel and lower speed when unloading so as to avoid material falling out of the shovel and outside the
tank.
2.7.5 FOOTPLATE
The footplate is hinged to the chassis. When closed, it enables safe driving from the ground
since there is no risk of its hitting the driver’s legs. When open, it allows the operator to drive
the machine in the on-board position. It is fitted with a vibration damper to protect the legs. For
total operator safety, the footplate is equipped with a lock (spring-loaded) which stops it from
closing accidentally.
2.7.6 USING THE AUXILIARY HYDRAULIC PTO AND SWITCHING
VALVE (fluid flow rate 26 l/min.)
The PTO terminals are located on the RH side of the machine. For ease of use, fit
the terminals with hydraulic snap fittings, male 3/8” and female 3/8”. To fit the snap
fittings, depressurise the hydraulic circuit by undoing the fluid filler cap, remove the
caps and fit the snaps fittings with their washers.
Now repressurise the circuit by extending all cylinders and tightening down the fluid
filler cap (see point 3.7). Fluid delivery is controlled with lever “G”. The fluid has a
two-way flow. Move the lever in the direction required to operate the tool. The lever
is equipped with a one-way lock to facilitate its use with special tools, such as the
cement mixer kit or implements to be operated at a distance such as hammers,
drills, shears and so on.
The auxiliary switching valve (lever “H”) enables and facilitates use of one-way
tools such as demolition hammers, hydraulic drills, water pumps, cement mixer kit,
etc.. Move the lever to the mark
to direct the return fluid flow directly to the tank
(see point 2-1-7).
LOADING
UNLOADING
Implement linkage control lever
Shovel control lever
Tank speed control
valve
Position of shovel
when unloading
Summary of Contents for CARRY 110
Page 2: ......
Page 49: ...TRACKED MINIDUMPER CARRY 110 PUBLISHED MARCH 2017 KATO IMER S p A ITALY ...
Page 50: ......
Page 51: ......