3
USER INSTRUCTIONS
MINIDUMPER
CARRY 105EP
17
3.5
LOADING AND UNLOADING THE MACHINE
MACHINE LOADING ONTO A TRUCK
To load and unload the machine ALWAYS use the ramps and
carefully follow the procedure given below.
1. Block the lorry wheels before loading the machine.
2. Lower the sides of the lorry.
3. Attach the ramps safely to the lorry. Maintain the slope of
loading ramps within 15 degrees. Position the machine so
that it can be run straight on the loading ramps.
4. Position the machine with the front facing the means of
transport with the tracks aligned with the loading ramps.
Never operate control levers other than the travel lever
while machine is on the lading ramps.
5. Maintain the machine balance point while travelling over
the loading ramp joint areas.
6. Make sure the ramps are stable.
BLOCKING FOR TRANSPORT
1. Stop the motor.
2. Engage the parking brake.
3. Block the tracks and secure the machine with tie-downs.
•
C
HOOSE AS FLAT GROUND AS POSSIBLE FOR LOADING THE MACHINE
.
•
W
HEN USING LOADING RAMPS
,
BE SURE THERE IS ADEQUATE LENGTH
,
WIDTH
,
FIRMNESS AND SLOPE
.
•
T
O PREVENT THE MACHINE FROM SLIPPING WHILE LOADING OR
S
HITFING TRANSIT
,
REMOVE ICE
,
SNOW OR
OTHER SLIPPERY MATERIAL FROM THE LOADING RAMPS AND THE TRUCK BED BEFORE LOADING
.
•
NEVER
OPERATE
AT FULL SPEED WHEN LOADING OR UNLOADING THE MACHINE ON A TRAILER OR A TRUCK
.
•
NEVER
MAKE A TURN ON A RAMP
.
T
O MAKE A TURN
,
GET OFF THE MACHINE FROM THE RAMP FIRST
.
DANGER
Summary of Contents for CARRY 105 ELECTRIC POWER
Page 2: ......
Page 47: ...TRACKED MINIDUMPER CARRY 105 ELECTRIC POWER PUBLISHED MARCH 2017 KATO IMER S p A ITALY ...
Page 48: ......
