Kato Imer CARRY 105 ELECTRIC POWER, Operating Instructions Manual

Page: 16 / 48

1 SAFETY
MINIDUMPER
CARRY 105EP
7
2. CLEANING THE MACHINE
Maintain the machine clean for safe operation. Remove any dirt or grease, check the supplied equipment.
Do not place anything flammable around the machine.
3. WASHING INSTRUCTIONS
Before washing the machine turn it off or disconnect it from the charger.
-
make sure there are no damaged parts and that the guards are all in place;
- do not overuse the water jet on the dashboard, inside the motor compartment, through the grilles and in
the battery compartments;
- use low pressure water and do not use solvents;
- after washing, compatibly with the weather conditions, wait for the machine to dry completely before
turning it on or recharging it;
- it is possible to use compressed air, being careful to avoid directing it on the aforementioned devices.
If the washing instructions have not been followed, wait a couple of days before using it again.
It is good practice to re-grease the parts that require lubrication if you believe it was removed during
the washing operations.
4. ADJUSTING HYDRAULIC PRESSURE
Only qualified person is allowed to gauge and adjust the hydraulic pressure following the specified procedure
and using the correct gauge if necessary.
If there is no qualified person, consult your local distributor.
5. PREVENTING FIRE AND EXPLOSIONS
Do not expose the vehicle to excessive heat, especially during recharging operations.
The batteries may explode if the vehicle catches fire.
Keep away fuel, lubricants and coolants from any fire or heat. Most of them are very flammable.
Do not use the machine in fire-sensitive areas or explosive hazardous areas or in underground areas.
NEVER SMOKE while using the machine or during maintenance operations or in a place close to
flammable objects.
5. MAINTENANCE OF THE HYDRAULIC SYSTEM
Before disconnecting hydraulic fluid lines on a hydraulic machine, be sure you:
-
shut off motor;
- place the shovel, if any, on the ground;
- the accessory is lifted and the safety retainer engaged;
- always release any pressurised air on hydraulic tank (by opening the fill cap);
- move control levers and pedals repeatedly through their operating positions to relieve pressure in the
cylinders.
Make sure all connections are tight and that lines, pipes, and hoses are in good condition before
starting the motor.
If you are struck by escaping hydraulic fluid under pressure, serious reactions can occur if proper
medical treatment is not administered immediately.
DANGER OF SHORT CIRCUIT. Remember that the batteries are supplied with energy and can
generate a short circuit in any part of the machine.