3
USER INSTRUCTIONS
MINIDUMPER
CARRY 105EP
16
3.2.3 SWITCHING OFF THE MACHINE
1. PARKED VEHICLE
To fully switch off the machine, turn the key to the OFF position (0).
This means the system is disconnected from the power supply and there will be no absorption from the
batteries.
2. EMERGENCY STOP
The machine has an emergency stop button: at any time, regardless of the operating mode,
it is possible to press the emergency button to disconnect the batteries or the power supply
from the rest of the system.
If the machine is not used for prolonged periods of time it is recommended to leave the
emergency button pressed.
3. SAFETY STOP
In the event of any anomalies related to the battery pack, the batteries' internal
management system can automatically switch off the machine to protect the operator from
any risks caused by using the machine in anomalous conditions.
3.3
PRE-HEATING THE MACHINE
With any piece of hydraulically operated equipment, it is extremely important that the hydraulic fluid be
thoroughly warmed fluid-up before any work is begun.
A warm-up period is time well spent in preventive maintenance. Practice the following warm-up procedure
before attempting full load operations.
1. Allow the motor to warm up at low idle for at least 5 minutes.
2. Activate the accessory's cylinder to heat the hydraulic components quicker.
3.4
LIFTING THE MACHINE
LIFTING PROCEDURE
The machine has 4 anchorage points
marked by special labels, two next the
driving levers and the other two at the front
of the machine.
1. Position the machine at level ground
with the accessory in a lowered position
and the shovel, if any, raised up high.
2. Stop the motor.
3. Connect the lifting straps to the 4 points
using 4 shackles with an adequate
capacity.
4. Attach the straps to the hook of the
lifting vehicle.
5. Check there are no obstacles or persons
around the machine.
6. Once the machine is lifted off the
ground, check that the machine is well
balanced.
•
U
SE PROPER RATED CABLES AND SLINGS FOR LIFTING
.
L
IFTING CABLES SHOULD HAVE SUFFICIENT LENGTH TO
PREVENT CONTACT WITH MACHINE
.
•
P
OSITION CRANE FOR LEVEL MACHINE LIFT
(
POINT
5).
•
NEVER
LIFT THE MACHINE LOADED WITH ANY PERSONNEL
.
•
U
SE SIGNS OR SIMILAR TO DELIMIT THE LOAD AREA
.
•
B
E SURE TO USE ARE WIRE ROPES AND OTHER DEVICES WITH A CAPACITY GREATER THAN
4
TONS
.
WARNING
Summary of Contents for CARRY 105 ELECTRIC POWER
Page 2: ......
Page 47: ...TRACKED MINIDUMPER CARRY 105 ELECTRIC POWER PUBLISHED MARCH 2017 KATO IMER S p A ITALY ...
Page 48: ......
