Kato Imer CARRY 105 ELECTRIC POWER, Operating Instructions Manual

Page: 14 / 48

1 SAFETY
MINIDUMPER
CARRY 105EP
5
2. BATTERY RECHARGE
Before connecting the vehicle to the electrical power supply, make sure the electrical system used
complies with safety standards. Namely, the electrical power supply should be protected against overcurrent
(e.g. with fuses or with a circuit breaker) and the differential protection device. If in doubt, contact your KATO
IMER dealer or the local electricity company.
The electrical wiring must have an effective grounding system.
Before connecting the vehicle to the electrical power supply, make sure the technical features of shunt
the are compatible with those required for the vehicle and indicated near the recharge socket. Only use
connectors compatible with the vehicle's socket.
FEATURES OF THE ELECTRICAL CONNECTION:
Voltage 230V +/- 10% - 50-60Hz
Maximum absorbed current 15 A
The power supply cable should be suited for frequent handling and have a scratch-proof coating (for
instance H07RN-F). If the cable is subject to wear or damage, replace it immediately.
Place the machine as close as possible to the electrical socket and avoid using long cables or
extensions that may get in the way. Safety extend the power supply cable and avoid placing in such a
manner that it may get in the way.
If using an extension or a multiple socket, check that they tolerate the overall amount of electricity
required.
Ensure he machine is well ventilated and check that the ventilation grid is not clogged.
Avoid connecting the machine to the socket when the cable, the connections or the battery
compartment on the machine are wet, and always follow the washing instructions.
Recharge the batteries in areas that are protected from the elements.
It is good practice to disconnect the vehicle from the charger once it has finished recharging. The word
FINISH will appear in the screen when the batteries are fully charged.
Perform the complete recharge equalization at least once a month to avoid batteries deteriorating
when the machine remains inactive for long periods.
B
EFORE CARRYING OUT ANY RECHARGING OPERATIONS MAKE SURE THAT THE MACHINE DOES NOT HAVE ANY
DAMAGED PARTS THAT CAN COME INTO DIRECT CONTACT WITH THE LIVE PARTS
.
I
F GENERATORS ARE BEING USED TO RECHARGE THE BATTERIES
,
MAKE SURE THEY ARE ELECTRONICALLY
STABILISED MODELS WITH A POWER OF AT LEAST
5
K
VA.
.
WARNING