Kato Imer CARRY 105 ELECTRIC POWER, Operating Instructions Manual

Page: 15 / 48

1 SAFETY
MINIDUMPER
CARRY 105EP
6
3. PRECAUTIONS WHEN USING THE EXTENSIONS
Avoid using extensions twisted in a helical fashion on the drums. If the mobile plug-type socket outlets
are positioned in transit areas, they should the adequately protected against mechanical damage.
The table below lists the recommended lengths according to the section of the conducting cable.
Power supply voltage/model
Recommended cable section
230V - 50-60Hz - 16A
Section (mm
2
)
2,5 4 6
Length (m)
0-15m 15-25m 25-40m
4. USING ELECTRICAL EQUIPMENT IN THE PRESENCE OF WATER
Avoid using the machine under heavy rain or water jets or if there is a large amount of water on the ground.
Take the usual precautions when using electrical equipment.
1.7 MAINTENANCE
1. ROUTINE MAINTENANCE
Maintenance work can be hazardous if not
done in a careful manner. All personnel
should realize the hazards and strictly follow
safe practices.
Before undertaking any maintenance or
repair work always consult the instruction
manual. Before ANY maintenance work, stop
the motor and engage the parking brake in
order to prevent any movement that may
cause damage to the operator. Lift the
accessory and introduce the special safety
retainer.
NEVER allow anyone to work on the undercarriage when the accessory is lifted and not properly
blocked.
During maintenance operations, mark the control levers with labels. These labels can only be removed by
aware personnel able to ensure that safety rules are fully observed.
Before working on the vehicle ensure it is disconnected from the electrical power supply and press the
emergency button.
The protections of the battery pack and the electrical panel may be removed only by personnel
authorised to do so, as even with the power supply cable disconnected from the electrical power supply, the
battery may still be loaded and they may be live parts.
The machine and its metal parts are connected to the ground circuit via the network cable. When the
network cable is disconnected the machine is isolated from the ground.
Namely, strong collisions or other accidents may cause the battery poles to come in contact with other
metal parts of the machine, especially the protections. Should this happen, before any other operations,
maintenance operators should always prevent this from occurring and check the potential of the protections.
SAFETY
RETAINER