6
STEP SEVEN
Select a nozzle (See page 8 for Nozzle and Pattern
Options). Insert the Shaft Bolt into the Nozzle Head
so it fits snugly into the molded socket. Install the
Nozzle by threading it into the inner cone of the
pump. Make sure to tighten the Nozzle all the way
down.
STEP EIGHT
Thread one rope through one Pipe Weight (Part M)
and position it approximately 6’ from the float. Next,
thread the end of the rope back through the opening
facing the float (as shown). Repeat with the second
rope and weight.
STEP NINE
Use the ropes to position the Fountain in the desired
location in the pond/lake. Anchor the ropes or secure
them to the shoreline so the ropes are free of slack,
but not tight. To prevent twisting of the unit due to
torque, you should place the anchor at least 3 feet
from the float for each foot of depth (Ex. A 6 foot
deep pond would require an anchor 18 feet horizon-
tally from the float.) For ease of removal, you may
choose to keep at least one anchor within reach from
shore, just below the water’s surface.
STEP SIX
Turn the assembly upright again. At this time, if the
cord contains a metal strain relief, you can use the
chain connector and attach it in one of the opening at
the rope placement. The chain connector will easily
fit if installed from the bottom or top side of the
opening. It will not fit if installed from side of open-
ing. Use the Nylon Cable Tie (Part J) included to se-
cure the power cord to a molded hole in the float to
prevent cord damage if there is no strain relief on the
cord. If a Strain Relief
is present on the cord,
you may disregard the
Nylon Tie. On cords
with a Quick Discon-
nect, the disconnect
should be tightened
properly to avoid leak-
ing. If installing a new
Quick Disconnect, refer
to Quick Disconnect In-
structions. Lights can
also be installed at this
time. Refer to Light Kit
Instructions.
Pictures corre-
spond with Step
Five from previ-
ous page
