MODEL: C85
DISPLAY AERATOR CONTROL WITH TIME SWITCH, GFCB,
LIGHTNING ARRESTOR AND 15 AMP GFCI LIGHTING RECEPTACLE
SUITABLE FOR USE WITH SUBMERSIBLE LIGHTS
IN RAINPROOF (TYPE 3R) ENCLOSURE SUITABLE FOR INDOOR OR OUTDOOR USE
40 AMP. MAX PER LEG 120/240 VOLT SINGLE PHASE (THREE WIRE) AC
PUMP CIRCUIT: 3 hp max, 240 Vac, LIGHT CIRCUIT: 120 Vac - 15 amp Max.
MIN 75˚ C SUPPLY CONDUCTORS
PHOTO CONTROL RATINGS: 120 VAC 50/60 HZ. 1800W TUNGSTEN, 8.3A BALLAST
LIGHTNING ARRESTOR RATINGS: 120/240 VAC; MCOV 250 VAC
Note: The short circuit current rating of this panel is 10,000 symmetrical amperes.
TIME SWITCH OPERATING INSTRUCTIONS
1. TO SET “ON” AND “OFF” TIMES:
Hold TRIPPERS against edge of
CLOCK-DIAL, pointing to time (AM or
PM) when
ON and OFF operations are
desired. Tighten tripper screws firmly.
2. TO SET TIME-OF-DAY:
Pull CLOCK-DIAL outward. Turn in
either direction and align the exact time-
of-day on the CLOCK-DIAL (the time
now, when switch is being put into
operation) to the pointer.
-DO NOT MOVE POINTER-
•
TO OPERATE SWITCH MANUALLY: Move MANUAL-LEVER
below left or right as indicated by arrows. This will not affect the
next operation.
•
FOR MORE THAN ONE DAILY ON-OFF OPERATION:
Place additional tripper pairs on CLOCK-DIAL (order
156T1978A).
•
IN CASE OF POWER FAILURE: Reset CLOCK-DIAL to proper
time of day. See step 2 above.
ON
TRIPPER
TIME
POINTER
TIME
DIAL
OFF
TRIPPER
MANUAL
LEVER
Wiring information-Copper
Conductors
Wire
Terminal
Size
Tightening Torque
AWG
Lb-In
14
20
12
20
10
20
8
25
6
35
4
45
3
50
2
50
L2
15 A
OPEN (20 A)
20 A
GFCB
L1
N
GND
.
TIMER
IMPORTANT:
This control panel must be installed
according to the National Electrical Code (including article 680)
and local code requirements. The main lugs and neutral main are
suitable for No. 14 to 2 AWG
COPPER conductors. Follow gauge
selection table and corresponding terminal screw tightening
torque requirements below. An additional branch circuit protector
(20 Amp max) may be installed in the unused position for use as
an auxiliary circuit. Use only Square D HOM Series circuit break-
ers for addition or replacement (do not exceed ratings on wiring
diagram). Follow Manufacturers instructions for testing of ground
fault circuit breakers (GFCB). This panel is equipped with a 120V
AC - 15 amp duplex GFCI receptacle for connecting a 120V AC
light kit or an external low voltage transformer for lighting. The
receptacle power is controlled by the timer-photoelectric circuit.
Refer to the instructions provided with your light kit. After wiring,
install front panel over wiring compartment.
KEEP DOOR CLOSED AT ALL TIMES.
KASCO MARINE, INC.,
800 Deere Road
Prescott, WI 54021-1241
•
Phone (715) 262-4488
PHOTO
CONTROL
RELAY
240V.
LIGHTNING ARRESTOR
158PS13244
UL508
UL1563
NEC 680
LR3730
T30004R30
